Products
The probe must be inserted directly into the bushing and remain free and clear of all surrounding surfaces. It is rated for use up to 21kV phase-to-ground. This probe should also be used in metal clad switchgear or any other applications where grounded or other live conductors may be in close proximity to the conductor being tested. TO
ASSEMBLE THE IEP-UD/C PROBE ON THE TAG-5000:
-
Inspect the IEP-UD/C probe for any mechanical defects andmake certain it is clean and dry.
-
Remove the overhead probe and screw the IEP-UD/C ontoeach TAG-5000. Make certain it is snug by hand tightening,but DO NOT OVERTIGHTEN.
-
Test the fully assembled TAG-5000 on a known voltagesource prior to using.
HD 电动 IEP-UD/C 绝缘地下套管探头
探头必须直接插入套管中，并保持自由并远离所有周围表面。 它的额定使用电压最高可达 21kV。 该探头还应用于金属包覆开关设备或任何其他应用，其中接地或其他带电导体可能靠近被测导体。 到
在 TAG-5000 上组装 IEP-UD/C 探头：
检查 IEP-UD/C 探头是否有任何机械缺陷并确保其清洁干燥。
取下高架探头并将 IEP-UD/C 拧到每个 TAG-5000 上。 用手拧紧确保它紧贴，但不要过度拧紧。
使用前在已知电压源上测试完全组装的 TAG-5000。
